Something went wrong while trying to load the full version of this site. Try hard-refreshing this page to fix the error.
Running DMA and TTL Edge counters in parallel
Artiq-flash in nix enviroment for ARTIQ development
Problems when installing ARTIQ on Linux
Sweep frequency DDS
Help request with scheduling stages
Urukul: parameter set speed / delay
Urukul board/channel as a parameter
Cannot set DDS after RAM ramp
Clocker Input Frequency
Fast ramps on Zotino
Slow record time for DMA. Problems getting many point, fast ramps
Event Callback failed
breakout for Sinara 2245 LVDS RJ45 TTL card
Delay not working?
Amplitude Modulation using TTL or Urukul channel
Reading status of a dds
Terminate run when using artiq_run
Running Urukul and Zotino ramps in parallel.
« Previous Page
Next Page »