We purchased a backplane adapter to get a few more EEM slots for our older Kasli v1.0. While I was about to install it, I noticed that the wiki specifies that it was designed for Kasli v1.1. There are a few small mechanical incompatibilities with our board: the holes for the 96-pin connector are slightly too far from the edge of the board to fit the connector (issue #1), and the rear power connector J17 will have to be removed. We can work around both of these, but I wanted to double-check before soldering - is the backplane adapter otherwise compatible with Kasli v1.0 from an electronics standpoint?