Hello,
Quick summary of the issue: can't flash Kasli board, following voltage indicators are not active: PWR GOOD, 1V2, 1V5, 2V5.
Longer version:
It appears we have an electronics issue with one of our kasli 2.0 boards. It was working fine a few months ago and has been sitting in a rack unused since. Last week I changed the cards in the crate and tried to reflash and got an error - that's when I noticed the voltage errors. As far as I'm aware I was grounded at all times, avoided touching the board, and didn't hotplug anything, but I did have to interact with the board to change the cables. It's the same power supply as when the board worked. No components are visibly damaged
Please advise on what I should check to see if there's a chance to fixing it here, or if I can send it back for repairs.
Some things I already measured on the board:
Input voltage is 12.35. Power supply specced at 12V 6A. Fan power has 12.35V on high and 2.8V on low (fan doesn't start). 1V2 pad reads 0.462 V. 1V5 reads 0.000. 2.5V reads 0.007 V. All others around nominal values.