Hi all,
I've been asked to re-install a damaged ARTIQ5 setup (broken Windows PC disk). I have two questions:
a) I'm positive they don't have the ARTIQ7 firmware. I'll try to double-check and make sure they don't have the ARTIQ6 firmware since, if they have it, I understand I could still re-install ARTIQ6 following the legacy windows instructions. If I understand it correctly, the conda channels there listed will provide version 6. I think that would be by and far the easiest think to do. Is that right?
b) If as I fear they are stuck with ARTIQ5, is it still possible to install ARTIQ5 with the legacy instructions? I don't think so, since the conda channels will provide version 6. Is there any channel name still available to refer to the ARTIQ5 software, or perhaps a different set of legacy instructions to re-install version 5?
Thanks for any help